nRF5x support within the Zephyr Project RTOS

RE: nRF5x support within the Zephyr Project RTOS

akash naidu — Wed, 21 Nov 2018 13:36:47 GMT

HI martin,

Thanks for sharing documentation link.

I will go through it and will come back, if i have got stuck somewhere.

Akash.

Martin Lesund — Wed, 21 Nov 2018 13:12:40 GMT

Hi Akash,

Regarding Zephyr, have you looked into the already made samples and documentation for mesh?

akash naidu — Wed, 21 Nov 2018 07:49:06 GMT

HI martin,

Is there any built in example for forming IPV6 mesh with BLE links?

My requirement is to establish mesh(at least 5 nordic bords) by using IPV6 over BLE.

Initially, i have tried on contiki OS but couldn't able to get any response from PCA10040.

So, now i have been trying on zephyr RTOS, in which i was able to getting response from Board.

Could you please guide me to form mesh on zephyr RTOS (or) Contiki OS?

Thanks in Advance

Akash.

akash naidu — Tue, 20 Nov 2018 13:40:45 GMT

HI Martin,

I have solved my issue.

Thanks for support

Akash.

Martin Lesund — Tue, 20 Nov 2018 12:55:36 GMT

Hi Akash,

If you are using PCA10040 you should use this command:

# Use cmake to configure a Ninja-based build system:
cmake -GNinja -DBOARD=nrf52_pca10040 ..

Documentation for PCA10040.

(I assume that you already have set up the Environment)