Trying to enable mesh proxy service

RE: Trying to enable mesh proxy service

Hung Bui — Fri, 04 Jan 2019 10:44:02 GMT

Yes, make sure before you test you erase the flash data. The flash manager module may mistakenly take the data of the previous firmware as the provisioning data.

RE: Trying to enable mesh proxy service

Mike — Thu, 03 Jan 2019 14:07:31 GMT

I discovered that when provisioning was loaded from flash, it the unicast address was set to 0. When I requested the unicast address over serial, it reported 0, so I thought it was unprogrammed and tried to set the unicast address. Since flash was already programmed, it did not save the new value, but the value in RAM was updated (which is where I thought there was a delayed load from flash). On the next powercycle, it loaded the 0 again, and did not start the proxy. I could fix this by clearing the flash data.

RE: Trying to enable mesh proxy service

Hung Bui — Thu, 03 Jan 2019 13:47:08 GMT

Hi Michael,

It's recommended to use latest SDK for your development (current SDK is v3.0)

Could you explain in more detail what exactly you want to do ?

If you don't plan to have GATT provisioning service, please set MESH_FEATURE_PB_GATT_ENABLED = 0

In addition even if you have MESH_FEATURE_PB_GATT_ENABLED = 1 , when the device get provsioned, it will automatically reset the softdevice so that it will work as Proxy node only as brinehart mentioned.

RE: Trying to enable mesh proxy service

brinehart — Fri, 28 Dec 2018 04:05:26 GMT

Once the node is provisioned the service will stop. What example(s) are you using?