RE: Cannot debug using Segger Embedded Studio

konsang — Tue, 22 Jan 2019 10:15:19 GMT

Hi,

I found the issue.

It is because I am using module from Laird manufacturer.

The module is pre-installed with bootloader firmware.

So, I need to erase the flash for the first time then program.

Thanks

Joakim Jakobsen — Tue, 22 Jan 2019 09:40:12 GMT

Hi.

Hard to say if this is related to any changes to the code, or hardware related.

I assume your application is based on an example from one of the latest versions of the SDK (with support for SES)?

[quote user=""]When I keep the main code small as possible, just toggle LED. The debug still cannot work. [/quote]

Does your application run as expected, apart from debugging not working? Are you able to toggle the LED?

Best regards,
Joakim.