Beware that this post is related to an SDK in maintenance mode
More Info: Consider nRF Connect SDK for new designs
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Linker error: address out of range for intel hex files

Hi,

I completed the getting started guide (Getting Started Assistant app) of the nRF Connect v2.6.1:

I installed the toolchain, the SEGGER Embedded Studio and opened a sample project of the sdk. When trying to build it I get following linker error (error also occurs when opening any other sample project):

1> Linking ‘zephyr.elf’
1> Post-link command
1> C:\gnuarmemb\8 2018-q4-major\bin\arm-none-eabi-objcopy.exe: zephyr.hex 64-bit address 0x4b4fa300000000 out of range for Intel Hex file
1> C:\gnuarmemb\8 2018-q4-major\bin\arm-none-eabi-objcopy.exe:zephyr.hex: bad value 

I have a nRF52840-Dongle (PCA10059) where I can upload new Hex-Files with the programmer app of the nRF Connect. But as far as I see this building this file is just the problem...

Does anyone have had the same problem or any idea what went wrong? Thanks!

Andreas

Related