Adding SAADC example to existing project

RE: Adding SAADC example to existing project

Simonr — Fri, 22 Mar 2019 08:03:01 GMT

This compells me to think that there is an issue with the NRF_LOG configuration. Have you set NRF_LOG_BACKEND_UART_ENABLED 1 as well. It won't do setting just the NRF_LOG_ENABLED 1. So please check that both of these are set to 1, and also that you have implemented NRF_LOG_BACKEND_UART_TX_PIN and NRF_LOG_BACKEND_UART_BAUDRATE as well.

Best regards,

Simon

RE: Adding SAADC example to existing project

qmorrison — Thu, 21 Mar 2019 19:38:06 GMT

No there are no build or compile errors. The project builds/compiles successfully, but when running the example, no output is displayed in the Terminal Emulator.

RE: Adding SAADC example to existing project

Simonr — Thu, 21 Mar 2019 09:17:35 GMT

Hi Darien

Does the project build properly? If you are missing header and/or .c you should get a "file missing" error when building it. Do you have any error code to provide so it will be easier to understand what exactly is wrong.

Best regards,

Simon

RE: Adding SAADC example to existing project

qmorrison — Wed, 20 Mar 2019 20:48:18 GMT

I believe we have all the necessary header and .c files, yes, and we did not have any compile or build errors. How would you recommend I make sure that I have all the necessary header and .c files?

Apologies for the delay in response, we were focusing on some Mesh stuff and had put this on the back burner for a little while

RE: Adding SAADC example to existing project

Simonr — Tue, 26 Feb 2019 07:53:11 GMT

Have you added all the necessary header and .c files from the saadc example to your project? Is it compiling and building without any errors? If not please specify which errors you are getting

RE: Adding SAADC example to existing project

qmorrison — Mon, 25 Feb 2019 21:30:50 GMT

Hi Simonr, yes, NRF_LOG is enabled in sdk_config.h, and the only log statements I'd like to see are the ones that come from the example.

RE: Adding SAADC example to existing project

Simonr — Wed, 13 Feb 2019 07:15:35 GMT

Hi Darien

Have you enabled NRF_LOG in your existing project? You will have to go through the sdk_config.h file in your existing project and make sure that the NRF_LOG functions have equal values to the saadc example. Easiest way is to just ctrl+F "NRF_LOG" in the two sdk_config files and control that all the functions are there and that the values are correct. You have to add NRF_LOG functions if they are missing from your project, but are present in the example.

Best regards,

Simon