Programming Thingy:52 with the mesh .hex via DK

RE: Programming Thingy:52 with the mesh .hex via DK

AndreasF — Tue, 26 Feb 2019 08:55:28 GMT

Hi.

Great to hear that you got it working :-) If you have any other issues, could you create another ticket? Since this ticket is quite long with all the logging pasted in the initial question.

Best regards,

Andreas

RE: Programming Thingy:52 with the mesh .hex via DK

Steve Butler — Tue, 26 Feb 2019 08:28:59 GMT

Hi Andreas,

I managed to get the Thingy:52's working with the nrfMesh app. (Though I'm unsure of why they flashed red but didn't work initially!)

Thanks a lot for your help.

Kind Regards,

Steve

RE: Programming Thingy:52 with the mesh .hex via DK

AndreasF — Tue, 26 Feb 2019 08:23:12 GMT

Hi Steve.

Did you follow all the steps in the guide (1-10)?

I followed the guide and set up 4 Thingy's:

Here, I've flashed 4 Thingy's with the firmware.

Then I used the nRF Mesh Mobile Application to provision them.

Each time I successfully provisioned one device this showed.

As each device is provisioned, the device LED turns to green, here I'm finished provisioning.

Did you have any issues with on of the steps?

Best regards,

Andreas

RE: Programming Thingy:52 with the mesh .hex via DK

Steve Butler — Mon, 25 Feb 2019 15:50:01 GMT

Hi Andreas,

No I hadn't. I'd connected to the Debug in rather than Debug out...apologies!

I've managed to program both hex files found in the github repository I posted a link to earlier to the thingy:52, and the LED flashed red like I believe it should. However the nrfMesh App still doesn't detect the thingy:52. Am I missing some steps?

Thanks for your help so far.

Kind Regards,

Steve

RE: Programming Thingy:52 with the mesh .hex via DK

AndreasF — Mon, 25 Feb 2019 14:08:59 GMT

Hi.

How did you program the Thingy:52?

Did you connect the Thingy to a DK like this?

Did you use nrfutil to proram with?

Best regards,

Andreas