HIDS Bluetooth Mouse Sample

RE: HIDS Bluetooth Mouse Sample

octvargas — Mon, 15 Jul 2019 13:59:10 GMT

RE: HIDS Bluetooth Mouse Sample

octvargas — Mon, 15 Jul 2019 13:51:44 GMT

Thanks Simon, that was 100% the problem. I guess my other issue right now is, when I try to connect the Mouse to my windows computer, it asks for a PIN but one wasn't provided, I don't think?

RE: HIDS Bluetooth Mouse Sample

Simon — Mon, 15 Jul 2019 08:58:34 GMT

The nRF9160 does not support Bluetooth, and that is the reason you are getting this error. However, you can still use the pca10090 board and the nRF52840 chip (which supports bluetooth). This can be done by setting SW5 to nRF52, and choosing the nRF52840 board when building your project.

I can see that the nRF9160 DK is listed under Requirements in the NCS documentation, and I think the intention is that you have to use the nRF52840 chip on the board.

I am sorry for not telling you this earlier, as I obviously should have seen this immediately. My mistake.

Best regards,

Simon

RE: HIDS Bluetooth Mouse Sample

octvargas — Thu, 11 Jul 2019 14:20:18 GMT

Additionally, when trying to do the Keyboard sample the exact same thing happens. When built as ns it has the same error in the same file. When built as a secure app it builds and loads just fine, but still can't connect and also get err-19 in addition to LEDs 1-4 all being constantly lit up.

RE: HIDS Bluetooth Mouse Sample

octvargas — Thu, 11 Jul 2019 13:15:10 GMT

So I built it as a secure app, which worked, I was able to flash over to the nRF9160, but I can't get it to connect or even appear in my available bluetooth devices. Furthermore, when I check the Link-Monitor I see that I get this error

Bluetooth init failed (err-19)

Please advise.

RE: HIDS Bluetooth Mouse Sample

octvargas — Thu, 11 Jul 2019 12:59:16 GMT

Thanks Simon, I'll try to build it as secure vs non-secure and see if that works, out of curiosity, what would I have to include in the header file in order to have it be defined.

Thanks again

RE: HIDS Bluetooth Mouse Sample

Simon — Thu, 11 Jul 2019 12:43:02 GMT

This error only shows up if you use the partition manager. If you choose the board nrf9160_pca10090 instead of nrf9160_pca10090ns you won't get this error. For some reason, the defintion PM_MCUBOOT_STORAGE_ID is not generated inside <..>\ncs\nrf\samples\bluetooth\peripheral_hids_mouse\build_nrf9160_pca10090ns\spm\zephyr\include\generated\pm_config.h. I am not sure why this is, but I can look into it if you would like to.

Best regards,

Simon