nRF24 Dongle not detected on the nRFgo Motherboard

RE: nRF24 Dongle not detected on the nRFgo Motherboard

ovrebekk — Wed, 14 Aug 2019 08:16:50 GMT

I am glad to hear you got it working with the ISP connector 🙂

These kits are quite old, and most of the people that worked on them are either out of the company, or has long since forgotten what they knew, so it's a bit difficult to support ;)

Best regards
Torbjørn

RE: nRF24 Dongle not detected on the nRFgo Motherboard

mmak — Tue, 13 Aug 2019 19:15:18 GMT

I don't have any other dongles that I could test on unfortunately. However I managed to flash onto the custom PCB using ISP connector so I could use this as a workaround!

Thanks a ton!

RE: nRF24 Dongle not detected on the nRFgo Motherboard

ovrebekk — Tue, 13 Aug 2019 10:17:08 GMT

Do you have any other dongles to try?

I have a bunch of older dongles laying about, and have experienced that not all of them can be programmed in this way.

[quote user="mmak"]I'm doing this as a workaround for now for my current project but I need a way to program the dongle as I have a custom PCB that I need to reflash. [/quote]

Are you flashing the custom PCB in the same way as the dongle?

Normally you would use the ISP connector on the motherboard to program external boards.

Best regards
Torbjørn

RE: nRF24 Dongle not detected on the nRFgo Motherboard

mmak — Mon, 12 Aug 2019 13:43:25 GMT

I've tried using another PC, couldn't flash onto the dongle either.

I'm able to flash onto the nRF2727 itself through the motherboard, just not the dongle. I'm doing this as a workaround for now for my current project but I need a way to program the dongle as I have a custom PCB that I need to reflash.

I can also enumerate the dongle if I plug it into my PC directly (can detect it in nrfgo studios as well under nrflu1+ bootloaders tab on the right), however my PC doesn't detect it if I plug it into the set up I took above.

As for the board ID, the ID is different everytime I plug it in -- 3 IDs I've seen were 0, 16, and 17.

RE: nRF24 Dongle not detected on the nRFgo Motherboard

ovrebekk — Mon, 12 Aug 2019 11:36:32 GMT

Your setup looks fine, and I was able to program one of my dongles with a similar setup (I also had a dongle that I was unable to program for some reason..)

Your board ID looks a bit abnormal, the board ID should be a number between 0 and 15 (it usually starts at 0 and counts up from there if you connect multiple boards).

Are you able to program the devkit module itself, or does it show similar issues?

Do you have another PC available that you could test on?

Best regards
Torbjørn

RE: nRF24 Dongle not detected on the nRFgo Motherboard

mmak — Fri, 09 Aug 2019 13:22:32 GMT

Hi!

The switch is currently set to VBUS. Here's an image of the setup:

S8 is also set to VBUS as well.

RE: nRF24 Dongle not detected on the nRFgo Motherboard

ovrebekk — Fri, 09 Aug 2019 11:15:12 GMT

What did you set the VTG/VBUS switch on the nRF2727 module to?

Are you able to send me a picture of your setup?

Best regards
Torbjørn