RE: SDK 15.3.0 FDS example putty terminal not displaying anything

BEplane — Thu, 21 Nov 2019 14:20:53 GMT

It would be very helpful if this information was in the infocenter example instructions. For this example and any example that use this feature. How else would I know this feature was used for this example?

I was able to get the serial cable to work, I believe it was a spotty connector that I replaced with a better one. But If I knew there was no need for an external serial cable I would have saved a lot of time.

Please update the documentation to include this information and make it more comprehensive of an example.

RE: SDK 15.3.0 FDS example putty terminal not displaying anything

Vidar Berg — Thu, 21 Nov 2019 14:06:38 GMT

Hello,

The Jlink programmer on the DK as a built-in serial bridge which is connected to P0.08 and P0.06 by default. So you shouldn't have to connect an external bridge to run this example. Does a "Jlink" com port appear in the device manager when you connect the board?

You should probably change the pin assignment for TX and RX if you want to use your bridge. P0.26 and P.27 for instance. These are not connected to anything else on the board.