NRF52832 module Interoperability

RE: NRF52832 module Interoperability

PKSHER — Fri, 29 Nov 2019 05:27:13 GMT

I appreciate your good support.

Regards,

RE: NRF52832 module Interoperability

bjorn-spockeli — Fri, 29 Nov 2019 00:54:00 GMT

Any Jlink programmer should be fine, i.e. any one of the programmers listed here: https://www.segger.com/products/debug-probes/j-link/models/model-overview/

Best regards

Bjørn

RE: NRF52832 module Interoperability

PKSHER — Thu, 28 Nov 2019 09:19:05 GMT

You have been very helpful. I appreciate it. One last question though, can I use stlink v2 dongle or any jlink/swd programmer in various development kits for programming this module, or do I need to purchase a new one? In the case of new one, kindly suggest one.

RE: NRF52832 module Interoperability

bjorn-spockeli — Wed, 27 Nov 2019 13:43:16 GMT

Yes, through the SWD interface.

Best regards

Bjørn

RE: NRF52832 module Interoperability

PKSHER — Wed, 27 Nov 2019 10:35:37 GMT

Ok, thanks, and also the process for uploading the firmware on both the modules will be the same. isn"t it?

RE: NRF52832 module Interoperability

bjorn-spockeli — Wed, 27 Nov 2019 07:45:08 GMT

Hi PKSHER,

If you develop the application code with nRF5 SDK, then you should be able to run the code on both the BMD 350 and the MS50SFB. Both modules does not have the external LF crystal so I do not think that any changes are necessary in terms of the SoftDevice initialization code at all. Both modules also support the same number of GPIOs so thats fine as well.

Best regards

Bjørn