Micro LIB Option in keil

RE: Micro LIB Option in keil

Asbjørn — Fri, 13 Feb 2015 12:50:21 GMT

So the code asserts when you get to connect? What do you mean the debugging didn't work? What didn't work? Have you done any changes to the startup file since you assume this is the cause of the issue?

RE: Micro LIB Option in keil

Dibin — Fri, 13 Feb 2015 04:29:16 GMT

Hi, The code I am using is from the GIT nRF51-ble-app-uart-static-passkey-master. The code stops when the application get connected to BLE mastert device. I tried to debug the issue but didnt work . Assuming its the issue with the startup file Regards, Dibin

RE: Micro LIB Option in keil

Asbjørn — Thu, 12 Feb 2015 19:16:05 GMT

Have you modified any of the code related to the UART example from our SDK? The default UART example shouldn't be affected by Micro lib option in Keil more that it would optimize the code. It should work with either selection. What is it with your code the doesn't work? Have your debugged to figure out where the code stops of which part of the code that doesn't work as intended?

RE: Micro LIB Option in keil

Dibin — Thu, 12 Feb 2015 04:43:34 GMT

I am sorry there was a mistake I have edited the question , Micro Lib option is not working for me .

RE: Micro LIB Option in keil

Asbjørn — Wed, 11 Feb 2015 17:19:35 GMT

I'm not sure if I understand your setup here. Are you seeing 400 bytes of difference when you add the softdevice to your project?