Get thread topology through wpantund | wpanctl.

RE: Get thread topology through wpantund | wpanctl.

jhc — Tue, 07 Jan 2020 01:17:05 GMT

Hi,msromero

Thank you for your information.

RE: Get thread topology through wpantund | wpanctl.

Marjeris Romero — Mon, 06 Jan 2020 12:49:50 GMT

Hi,

Right now I don't think it's possible to use NCP as a topology monitor device.

You can run Spinnel CLI on NCP nodes (https://github.com/openthread/pyspinel) which supports a limited set of CLI commands, but it does not have support for sending MGMT_DIAG messages. Please take a look at this comment by one of our developers.

Best regards,

Marjeris

RE: Get thread topology through wpantund | wpanctl.

jhc — Fri, 03 Jan 2020 23:47:49 GMT

Thank you, msromero

Sure, I know how to get the diagnostic information of all nodes using CLI commands, but do not know how to get these informations when using NCP commands (on the Raspberrypi board). Does NCP also support CLI command?

RE: Get thread topology through wpantund | wpanctl.

Marjeris Romero — Fri, 03 Jan 2020 13:04:29 GMT

Hi,

Have you seen the 'Principle of operation' section at the infocenter page for the TTM? Using CLI commands you can print a table of attach routers in a network and then print the diagnostic information of each router and child.

RE: Get thread topology through wpantund | wpanctl.

jhc — Thu, 26 Dec 2019 08:19:26 GMT

Hello all, could anybody help me?😘