Unable to bond after connect to nrf52832 using nrfConnect on mobile

RE: Unable to bond after connect to nrf52832 using nrfConnect on mobile

Nilesh Patil — Tue, 14 Jan 2020 08:47:33 GMT

Thanks , It is done from android app side.

RE: Unable to bond after connect to nrf52832 using nrfConnect on mobile

Hung Bui — Thu, 09 Jan 2020 12:14:23 GMT

You may need to write your own app that would do re-connect periodically. I'm not the expert on the phone's side.

Another option is to make your device looks like a mouse/keyboard (implement keyboard/mouse service in your GATT table), this way the phone operating will connect to the device automatically.

RE: Unable to bond after connect to nrf52832 using nrfConnect on mobile

Nilesh Patil — Thu, 09 Jan 2020 11:05:32 GMT

Okay Thanks, Hung Bui

Now I tried with "Auto Connect" as you told but following points are observed,

1) It is not reconnect automatically when I OFF the Mobile Bluetooth and ON it again.

2) It is connect automatically when I restart the Thingy.

Is there any other configuration to do?

RE: Unable to bond after connect to nrf52832 using nrfConnect on mobile

Hung Bui — Thu, 09 Jan 2020 09:57:58 GMT

The Thingy firmware doesn't support bonding. Even if it support bonding it also doesn't guarantee that the phone will automatically reconnect when the device in range. The phone only reconnect to a bonded device if it's a HID (keyboard/mouse) device.

If you want the phone to reconnect automatically, please check the check box "Auto Connect" inside the Connect option (3 dots) in nRF Connect. However the app has to be running.

RE: Unable to bond after connect to nrf52832 using nrfConnect on mobile

Nilesh Patil — Thu, 09 Jan 2020 04:42:12 GMT

Hi Hung Bui,

I have connected the device with the nRFConnect android app. It is connected successfully. Now I need to reconnect whenever it comes in the range in future. For that I need to bond it. When I select the Bond option in nRFConnect then It shows status "Bonding.." for 5-10 seconds and then showing "NOT BONDED".

RE: Unable to bond after connect to nrf52832 using nrfConnect on mobile

Hung Bui — Wed, 08 Jan 2020 12:27:26 GMT

Hi Nilesh,

Could you elaborate more on the issue you have ? When you tried to bond, what happened ?
Have you tried to erase bond on the phone ? (Bluetooth Setting)