RE: ancs on pca10028

pbljung — Wed, 18 Mar 2015 20:26:25 GMT

That is what I have been doing, but I always get Received Link Loss error.

In Master Control Panel I select File>FlashProgramming. I select the MEFW 0.9.0 and click program.

In Master Control Panel I select File>ServerSetup, then File and select ANCS_central.bin. I stop the server, and then I re-start the server. I close the server setup window.

I click Discover, MCP finds the ANCC device. I click ANCC and click select device. I click connect, and the console reports connected, and 5s later it reports that connection parameters are updated.

I click Bond, MCP console reports encryption change, then a few seconds later there is the error "Received link loss".

The last lines of the MCP log (attached) shows that there is a BTLE connection timeout, and then a link loss is reported. How to proceed?

log MCP 20150316.rtf

RE: ancs on pca10028

Asbjørn — Wed, 25 Feb 2015 08:42:01 GMT

I tried your setup here now and on the first attempt I selected the ANCS device and then I pushed "Bond". When I did this I ran into the same behavior as you do. If I however select the same device, but before bond I push "Connect" and then "Bond" and then discover services everything was working as intended.

Which MEFW are you using on the PCA10000? Make sure you use the 0.9 version of MEFW.