nrf52840 study

RE: nrf52840 study

Einar Thorsrud — Mon, 03 Feb 2020 13:19:27 GMT

I see. Please note that unlike Arduino, the nRF5 SDK is tailored for embedded professionals, and you are expected to have a decent knowledge of embedded systems and C programming. With that basis, you should use the SDK documentation and refer to examples to learn the nRF SDK.

Regarding what you want to do, it is important to know how you interface with the sensor. Is it, for instance, using I2C (TWI) or SPI? Then you should refer to SDK examples for the relevant peripheral, and learn how to use it based on the SDK documentation and example. You would have to implement support for your sensor using its datasheet to know how you communicate with it.

RE: nrf52840 study

saver — Mon, 03 Feb 2020 13:10:50 GMT

I want to connect a imu sensor g-271 to the board and take the x y z axis readings. Iam new to the board so that basically I dont understand the coding , I have only experiences with arduino.

RE: nrf52840 study

Einar Thorsrud — Mon, 03 Feb 2020 13:08:30 GMT

Can you elaborate on what you are looking for?

RE: nrf52840 study

saver — Mon, 03 Feb 2020 12:57:35 GMT

The commands are too tough to understand the purpose.

And the documentation is,way too harder could you suggest me some simpler things

RE: nrf52840 study

Einar Thorsrud — Mon, 03 Feb 2020 10:33:44 GMT

Hi,

I recomend you start playing with SDK examples and review SDK documentation as needed. I suggest you start by reading SDK Getting Started.