Problems with Flashing and GPIO enabling | nRF52840

RE: Problems with Flashing and GPIO enabling | nRF52840

Simonr — Thu, 06 Feb 2020 14:19:40 GMT

Do you get an error of any kind when trying to use P1.09 as a GPIO? The only thing I can think that might have happened is that this is used as a TRACE pin, but this should be disabled by default in our examples. You can try setting the TRACECONFIG->TRACEMUC field to 0, just keep in mind that only bit 16 and 17 should be set, and the rest of the TRACECONFIG register should be left as is.

Best regards,

Simon

RE: Problems with Flashing and GPIO enabling | nRF52840

utpal — Thu, 06 Feb 2020 10:52:41 GMT

Hi Simon,

Thanks.

Yes disabling the UART debugging in sdk_config.h i am able to use the GPIO mode,which i used for SPI communication ie P0.06, P0.08, P0.04 and p0.12.

But I am struck with P1.09, this is not working as GPIO, but it's not a blocking issue now as we are using this as INTERRUPT to main controller.

Above all we done to check the PCB connectivity check to controller, purpose is to use all the above mentioned GPIO as SPI lines as mentioned below:

#define S32_SPIS_CS_PIN           NRF_GPIO_PIN_MAP(0,6) //231 y
#define S32_SPIS_MISO_PIN         NRF_GPIO_PIN_MAP(0,8)//235 y
#define S32_SPIS_MOSI_PIN         NRF_GPIO_PIN_MAP(0,4) //230 y
#define S32_SPIS_SCK_PIN          NRF_GPIO_PIN_MAP(0,12) //237 y

But for SPI communication

#define S32_SPIS_CS_PIN    6 //P0.06
#define S32_SPIS_MISO_PIN    8 //P0.08
#define S32_SPIS_MOSI_PIN    4 //P0.04
#define S32_SPIS_SCK_PIN     12 //P0.12

#define S32_BT_INT_PIN NRF_GPIO_PIN_MAP(1,9) //241 not able to work as GPIO

    nrf_drv_spis_config_t spis_config = NRF_DRV_SPIS_DEFAULT_CONFIG;
    spis_config.csn_pin               = S32_SPIS_CS_PIN;
    spis_config.miso_pin              = S32_SPIS_MISO_PIN;
    spis_config.mosi_pin              = S32_SPIS_MOSI_PIN;
    spis_config.sck_pin               = S32_SPIS_SCK_PIN;

APP_ERROR_CHECK(nrf_drv_spis_init(&spis, &spis_config, spis_event_handler) );

Kindly guide on SPI interface and P1.09 as GPIO.

RE: Problems with Flashing and GPIO enabling | nRF52840

Simonr — Tue, 04 Feb 2020 14:03:59 GMT

The GPIO issue is pretty straight-forward I think. If you have enabled debug logging P0.06 is the default pin for sending data to the debugger.

As for the flashing issue, I think I'll need some more information. Are you using an nRF52840 DK as a debugger or another JLink device? Do you have to flash the same code twice every time in order for it to run on your device? What do you mean by "Currently the random flashing also not giving solution."?

Please confirm that your custom board is connected to the debugger like this if you're not using a 10pin debug cable:

Best regards,

Simon