Softdevice assert: 86108:0

RE: Softdevice assert: 86108:0

inv4 — Sat, 22 Feb 2020 21:08:48 GMT

Ive solved it changing the accuracy.

RE: Softdevice assert: 86108:0

inv4 — Sat, 22 Feb 2020 00:43:46 GMT

It works! although I dont know if its normal that sometimes it takes several tries to connect succesfully, the first two or so tries it just goes back to the discovery of avaliable nodes without a succesfull connection and no error or log on the node that Im trying to connect via the mesh app.

RE: Softdevice assert: 86108:0

Hung Bui — Fri, 21 Feb 2020 09:07:18 GMT

Could you confirm that the same firmware (light switch example) can run on the DK and Rigado with no problem ?
Please make sure you have erased the chip (erase full chip) before testing with your board.

Please try testing with the LFCLK set to RC (Set NRF_SDH_CLOCK_LF_SRC in sdk_config.h to 0 and NRF_SDH_CLOCK_LF_RC_CTIV = 16)

If the issue persist please send us the schematic, and the full log when the issue occurs (you can increase the log level to DEBUG)

RE: Softdevice assert: 86108:0

inv4 — Fri, 21 Feb 2020 07:41:48 GMT

Im using the dimmable server example from experimental but I have tried the switch server example.

By manually disconnecting the node I mean that once I provisioned the node it stays connected to that node and to the network, it can repeat messages and everything works great, but if I press disconnect on the mesh app and then I scan for provisioned nodes it shows up, but the node keeps halting like 20 seconds or so from start.

The module has already in place the HFCLK from the factory and I added the LFCKL which is a 32.768KHZ whid a +20ppm

-20ppm

RE: Softdevice assert: 86108:0

Hung Bui — Thu, 20 Feb 2020 12:54:52 GMT

Hi,

Could you explain what exactly you meant by "manually disconnect the node" and "connect to it again" ?
The assert from the softdevice prompts that it could related to the timeslot event being used longer than it should. It could be something to do with timing.
Which external crystal do you use ? Is it for the HFCLK or the LFCLK ? Could you send the schematic of the board ?

Which example did you use to test ?