RE: Add Include Paths under SEGGER Embedded Studio 4.42a

li0than — Tue, 03 Mar 2020 13:46:27 GMT

Thanks, the Problem originated in the wrong selection of the board version. Now it works 👍

[quote userid="81181" url="~/f/nordic-q-a/58560/add-include-paths-under-segger-embedded-studio-4-42a/237767"]nrf9160_pca10090ns board (notice the "ns" at the end).[/quote]

RE: Add Include Paths under SEGGER Embedded Studio 4.42a

Didrik Rokhaug — Tue, 03 Mar 2020 13:23:37 GMT

Hi.

nRF Connect SDK (NCS) projects are configured from CMake, not Segger Embedded Studio (SES). The infocenter guide you linked to refers to the nRF5 SDK and is not valid for NCS.

The sample should run out of the box, with no need for modifications.

What board did you select when opening the project, and did you get any errors when opening it?

The bsdlib can only be used from applications running as non-secure. To configure an application as non-secure, you must build the project for the non-secure version of the board. E.g. for the nRF91DK, you must select the nrf9160_pca10090ns board (notice the "ns" at the end).

Can you try to open the project again, this time making sure that you select the non-secure version of the board (and remember to clean the build folder)?

Best regards,

Didrik