NRF GPIO Example OutPut Write

RE: NRF GPIO Example OutPut Write

Jørgen Holmefjord — Wed, 18 Mar 2020 09:13:34 GMT

That is not configurable in SW, this is an HW decision that is made by the board designer. The LEDs are physically connected either between VDD and the GPIO or between GND and the GPIO.

RE: NRF GPIO Example OutPut Write

SachRafa — Tue, 17 Mar 2020 18:19:34 GMT

Hi Jorgen,

Thanks for the update. How to configure the LED to connect between GPIO and ground?

BR,

Rafa.

RE: NRF GPIO Example OutPut Write

Jørgen Holmefjord — Tue, 17 Mar 2020 08:59:44 GMT

Hi,

This depends on how the LEDs are connected. On our DKs, the LEDs are active low and are connected between the GPIO and VDD. This means that if the GPIO is set high (i.e. VDD), both nodes of the LED will have the same voltage potential and no current will flow through it. When the GPIO is cleared (i.e. GND), the voltage difference between the two nodes will create a current flow, lighting up the LED.

It would also be possible to connect the LED between the GPIO and GND. In that case, you would use SET and CLR to turn on and off the LED as you expect. The main reason for using active low LEDs is that the GPIOs of the nRF5x ICs can sink (i.e. receive) more current than it can source (i.e. send out).

Best regards,
Jørgen