choco install ninja command not verify in nrf connect application

RE: choco install ninja command not verify in nrf connect application

shital — Tue, 07 Apr 2020 09:30:39 GMT

hello torsten

Thanks for your reply.

when try a CMake in the command prompt getting bellow error.

thanks

shital

RE: choco install ninja command not verify in nrf connect application

shital — Tue, 07 Apr 2020 09:19:09 GMT

hi oyvind

yes install CMake without any error, and run choco install ninja comand without error but when check version getting below message.

thanks

shital

RE: choco install ninja command not verify in nrf connect application

Torsten Rasmussen — Tue, 07 Apr 2020 09:06:32 GMT

Hi Shital,

Could you see if there is a more detailed log in the `Output` (console) window in SES after clicking `OK`.

If that show no extra info, then maybe try a CMake in the command prompt, to see if that also produces a CMake error:

set ZEPHYR_BASE=c:\Nordic_SDK\ncs\zephyr
cd c:\Nordic_SDK\ncs\nrf\applications\asset_tracker
cmake -GNinja -DBOARD=nrf9160_pca10090ns -Bbuild .

RE: choco install ninja command not verify in nrf connect application

Øyvind — Mon, 06 Apr 2020 18:37:05 GMT

Hi Shital,

The error message says "could not finish CMake", did you install CMake without issues? What issues are you seeing with ninja?

In the command line, what does the following output:

cmake --version

ninja --version

RE: choco install ninja command not verify in nrf connect application

shital — Wed, 01 Apr 2020 14:32:57 GMT

hello Oyvind

Thanks for your reply.

when run choco ninja command ,did not get any errors.

but when open project in segger studio getting below error and project dose not open.

thanks and regards

shital

RE: choco install ninja command not verify in nrf connect application

Øyvind — Wed, 01 Apr 2020 09:49:06 GMT

Hello,

The verification in the Getting Started Assistant is not that important. When running choco install ninja, did you get any errors? Did you check that Ninja actually works?

Kind regards,
Øyvind