Unable to detect multiple light devices after provisioning on nrf Mesh application

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

ggk4u — Wed, 06 May 2020 10:18:33 GMT

I am working on microbit with mesh switch and light compiled on zephyr...

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

Joakim Jakobsen — Wed, 06 May 2020 10:13:24 GMT

Which version of the nRF5 SDK for Mesh are you working with?

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

ggk4u — Thu, 30 Apr 2020 11:05:28 GMT

I mean 'uuid' in 'bt_mesh_prov' structure.

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

Joakim Jakobsen — Thu, 30 Apr 2020 10:29:54 GMT

Could you elaborate on what you are referring to with "dev_uuid[]"?

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

ggk4u — Mon, 27 Apr 2020 10:55:15 GMT

Hi,

I observed that when I change dev_uuid[] and flash it for each device then they are visible after provisioning, Can I make the code to chose it dynamically instead of hardcoding?

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

Joakim Jakobsen — Sun, 19 Apr 2020 23:37:38 GMT

Well, after the nodes are provisioned they won't appear in the list when scanning for unprovisioned devices. After provisioning they should be visible as nodes that are a part of your network.

Best regards

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

ggk4u — Fri, 17 Apr 2020 11:09:24 GMT

No they are not getting unprovisioned, The are not listed again in scanner, I could able to control them with the switch as well, Only issue is they are not visible in the network...

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

Joakim Jakobsen — Fri, 17 Apr 2020 07:36:00 GMT

Ok, as long as the unicast address is different from the nodes that is being provisioned there shouldn't be any problems.

Are you able to see any logs from the provisioned devices? Are they going back to provisioning as an unprovisioned device when you provision a new device?
Do they reappear for the scanner when they disappear from your network list?

Best regards,
Joakim

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

ggk4u — Thu, 16 Apr 2020 06:49:04 GMT

Do I need to set any particular config for this?

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

ggk4u — Thu, 16 Apr 2020 06:47:57 GMT

Yes, the unicast address of each device is different but after provisioning only the latest is visible in the network.

RE: Unable to detect multiple light devices after provisioning on nrf Mesh application

Joakim Jakobsen — Thu, 16 Apr 2020 06:17:55 GMT

Hi.

That sounds strange.

Have you made sure that the Mesh app is provisioning the devices with different addresses?