How to use RTT viewer with custom board

RE: How to use RTT viewer with custom board

choehyunho — Fri, 24 Apr 2020 11:37:01 GMT

After upgrading J-Link to 6.70G, RTT viewer is working. Thank you for support.

RE: How to use RTT viewer with custom board

Vidar Berg — Thu, 23 Apr 2020 11:24:26 GMT

Hi,

The RTT Viewer settings are correct at least. Please make sure there aren't any other active Jlink connections when you try this (eg active debug session in SES), and try to update to the latest J-link SW if it still doesn't work.

RE: How to use RTT viewer with custom board

choehyunho — Thu, 23 Apr 2020 08:22:22 GMT

Hi.

Correct. I can see messages in SES debugging session, but not in RTT viewer.

As you can see the below capture, I have nothing special config when I connected to 52833 DK.

Should I change something in my custom board?

RE: How to use RTT viewer with custom board

Vidar Berg — Wed, 22 Apr 2020 08:30:03 GMT

Hi,

So to confirm, are you able to view RTT messages from your custom board in the SES debug terminal, but not with the RTT viewer? The problem is likely with the RTT viewer or its configuration then, not with your board or FW.