nRF Thread Topology Monitor v0.1.3.0

RE: nRF Thread Topology Monitor v0.1.3.0

Sampath P — Mon, 26 Jun 2023 10:41:51 GMT

Hello, thanks for the response.

I have a question regarding the powering of the nrf board.Im powering my nrf board with the solar power manager and i was thinking of adding a battery gauge(lipo fuel gauge) to this setup.Is it possible to do this with nrf52833dk?

ps:Im trying to create a new ticket, but i dont know why that page of your site is always freezing on my pc.

RE: nRF Thread Topology Monitor v0.1.3.0

Jørgen Holmefjord — Wed, 21 Jun 2023 11:32:51 GMT

The Topology monitor will not show any information about transmissions between routers or end nodes in the network. As the name suggests, this tool will only show the Topology of the network. If you want to see packet exchange between nodes, you need to use the nRF Sniffer for 802.15.4.

RE: nRF Thread Topology Monitor v0.1.3.0

Sampath P — Wed, 21 Jun 2023 11:03:29 GMT

Thankyou for the response, I was able to solve the issue.I was successful in establishing a mesh topology among my boards, but when im transmitting data from one router to another ,im not receiving any sort of prompt of log info regarding the transmission on my topology monitor.can you please help?

RE: nRF Thread Topology Monitor v0.1.3.0

Jørgen Holmefjord — Tue, 20 Jun 2023 10:48:53 GMT

You need to program the hex-file to the Dongle/DK, as described in the documentation: Connecting to a Thread topology

RE: nRF Thread Topology Monitor v0.1.3.0

Sampath P — Tue, 20 Jun 2023 10:40:48 GMT

Hello, what did you mean by "tested with the firmware"?,I found the hex file in the package but i dont understand how to proceed further as I'm facing the same error.

RE: nRF Thread Topology Monitor v0.1.3.0

Jørgen Holmefjord — Tue, 12 May 2020 08:02:48 GMT

I did a comparison on the files, and they match the precompiled CLI hex-files in nRF5 SDK for Thread and Zigbee v4.0.0. There could be small changes in the CLI output between different release versions, leading to TTM not receiving the expected response for a command.

RE: nRF Thread Topology Monitor v0.1.3.0

Farhang — Mon, 11 May 2020 18:19:14 GMT

OK Thank you! Using the .hex files in the TTM zip worked.

Do you know what version of "nRF5_SDK_for_Thread_and_Zigbee" where those compiled from?

Any known reason why is the doesn't work with 4.1.0?

Thanks again for the prompt replies.

RE: nRF Thread Topology Monitor v0.1.3.0

Jørgen Holmefjord — Mon, 11 May 2020 16:58:19 GMT

No, I'm referring to the hex-files in the hex directory that is included in the Thread Topology Monitor ZIP file.

RE: nRF Thread Topology Monitor v0.1.3.0

Farhang — Mon, 11 May 2020 16:12:56 GMT

I quoted the exact path of pre-compiled FWs I used at the end of my post. Is that what you're referring to? Yes those were part of the zip package download of the SDK.

RE: nRF Thread Topology Monitor v0.1.3.0

Jørgen Holmefjord — Mon, 11 May 2020 12:46:40 GMT

Hi,

Have you tested with the firmware that comes with the application, found in the hex directory?

Best regards,
Jørgen