Single central multiple peripheral is not working

RE: Single central multiple peripheral is not working

Amanda Hsieh — Mon, 13 Jul 2020 12:34:59 GMT

Hi Carly,

Could you erase the board (1D:EE:13:3A:BB:DF) and load UART/Serial Port Emulation over BLE image again?

Please let me know how it works. Thanks.

-Amanda H.

RE: Single central multiple peripheral is not working

shikgom2 — Thu, 09 Jul 2020 09:19:11 GMT

Thanks for your answer.

I didn't modify the example code, I erase j-link and build again, But the same error occurred.

And, I use the terminal tool, There is no data coming from COM PORT.

When I added nrf_delay_ms() during BLE connection time, But It didn't work very well...

Maybe I solve NRF_SOLVE_BUSY this error first.

how Can I solve this error?

RE: Single central multiple peripheral is not working

Amanda Hsieh — Thu, 09 Jul 2020 08:45:57 GMT

Hi Carly,

Did you modify the example? If so, what did you modify?

For the first error, please erase the kit before downloading the image.

For the second figure, you have to send data to one of the boards using the serial port. Observe that the data is displayed on the UART on the other board. Please use the terminal tool like putty to connect the central and the peripheral. You will get peripheral's tx data on the UART.

-Amanda H.

RE: Single central multiple peripheral is not working

Amanda Hsieh — Wed, 08 Jul 2020 13:31:36 GMT

Hi Carly,

I am working on your case and will reply later. The support staff is reduced during the summer holidays, and you may experience delayed answers.

-Amanda H.