How to run demo after builded

RE: How to run demo after builded

Simon — Fri, 24 Jul 2020 12:18:57 GMT

Check out this: https://www.youtube.com/watch?v=YZouRE_Ol8g&list=PLx_tBuQ_KSqGHmzdEL2GWEOeix-S5rgTV

Best regards,

Simon

RE: How to run demo after builded

jictannu — Fri, 24 Jul 2020 09:08:45 GMT

Hi Simon, I try to download zephyr.hex by JFlash, it works until I click disconnect. It looks like only work when it connect to JLink.

RE: How to run demo after builded

jictannu — Fri, 24 Jul 2020 03:51:15 GMT

Hi Simon。 Could you please tell how to do in SEGGER Embedded Studio?

RE: How to run demo after builded

Simon — Thu, 23 Jul 2020 10:20:43 GMT

I just tested this with an nRF52832 (I don't have an nrf52811 at hand at the moment) using NCS v1.3.0, the sample ncs/v1.3.0/zephyr/samples/bluetooth/beacon, and Termite with the following UART settings:

It works without starting a debug session (just west build -b nrf52dk_nrf52832 && west flash):

*** Booting Zephyr OS build v2.3.0-rc1-ncs1  ***
Starting Beacon Demo
Bluetooth initialized
Beacon started
[00:00:00.006,561] [1B][0m<inf> bt_hci_core: HW Platform: Nordic Semiconductor (0x0002)[1B][0m
[00:00:00.006,591] [1B][0m<inf> bt_hci_core: HW Variant: nRF52x (0x0002)[1B][0m
[00:00:00.006,591] [1B][0m<inf> bt_hci_core: Firmware: Standard Bluetooth controller (0x00) Version 2.3 Build 0[1B][0m
[00:00:00.007,171] [1B][0m<inf> bt_hci_core: Identity: d4:83:20:fe:9e:4c (random)[1B][0m
[00:00:00.007,202] [1B][0m<inf> bt_hci_core: HCI: version 5.2 (0x0b) revision 0x0000, manufacturer 0x05f1[1B][0m
[00:00:00.007,202] [1B][0m<inf> bt_hci_core: LMP: version 5.2 (0x0b) subver 0xffff[1B][0m

Could you test the same setup as me (NCS v1.3.0 and Termite) and see if it works or not.

Best regards,

Simon

RE: How to run demo after builded

jictannu — Thu, 23 Jul 2020 01:10:17 GMT

Hi, Simon. The baud rate is correct, because if I start debug or click Connect J-Link, it works

RE: How to run demo after builded

Simon — Thu, 23 Jul 2020 00:42:56 GMT

Have you checked if the baud rate is set correctly?

Best regards,

Simon