FCC/IC/ETSI certification procedure

RE: FCC/IC/ETSI certification procedure

Andreas — Mon, 27 Jul 2020 08:51:34 GMT

Hi,

You can enable RX mode on your DUT. Using a second device as TX, on the same channel, same mode and not random payload, you can print the received packets from the DUT.

You can also do this with DTM in nRF Connect for desktop.

Best regards,

Andreas

RE: FCC/IC/ETSI certification procedure

Sridhar Jonnavittula — Fri, 24 Jul 2020 12:19:29 GMT

Using only our board with radio test example, how can we verify radio receiver path? Does lab mandatory verifies RX path also?

RE: FCC/IC/ETSI certification procedure

Andreas — Fri, 24 Jul 2020 11:48:33 GMT

Hi,

Our impression is that it really comes down to what the lab prefers, it should be acceptable but some might ask you to bring a different kind of FW or setup. Also note that DTM is a BLE spec, if you use e.g. 802.15.4 you will not be able to test that with DTM.

Best regards,

Andreas

RE: FCC/IC/ETSI certification procedure

Sridhar Jonnavittula — Fri, 24 Jul 2020 11:42:37 GMT

Currently we are verifying using DTM TX and RX under nRF Connect for desktop. Is that acceptable in Lab?

RE: FCC/IC/ETSI certification procedure

Andreas — Fri, 24 Jul 2020 11:24:15 GMT

Hi,

You should confirm with your test house what they prefer. DTM can be used, but for regulatory testing the "radio test example" (also in the SDK) is more flexible.

Best regards,

Andreas