nRF52833 direction finding

RE: nRF52833 direction finding

Simonr — Fri, 21 Aug 2020 11:16:23 GMT

Hi again

As I mentioned, you will need an additional antenna array so that the nRF52833 can use antenna switching in order to transmit (or receive, depending on whether you're using AoA or AoD) to/from the different antennas which will make it possible to calculate the angle of arrival/departure. This is mentioned in the whitepaper I linked to, so please take a look at that for more information.

Best regards,

Simon

RE: nRF52833 direction finding

malik — Fri, 21 Aug 2020 08:30:42 GMT

what will be the impact of using only two chips of nRF52833, one as TX and other as RX, i know that both are equiped with only one built-in antenna. Based on this, collecting CTE and IQ samples from both Chips and further analysing this data for direction finding ? how do you see this Approach ?

Thanks for your support

RE: nRF52833 direction finding

Simonr — Fri, 21 Aug 2020 08:22:49 GMT

The CTE and IQ sampling features are described in the nRF52833 product specification on how CTE and IQ sampling is done. You will need to use an antenna array for direction finding, so this will need to be taken into consideration when designing a board. You can also check out our blogs on direction-finding and the Direction Finding whitepaper on the infocenter for more details on Direction-finding in general.

We have not released any HW for a direction-finding antenna array as of yet, and you will have to contact the regional sales manager (RSM) of your area for a roadmap of when this and/or a software solution can be expected. If you don't have their contact information please fill out our Sales Related Questions form here to get in touch.

Best regards,

Simon