Change mcuboot_menuconfig configuration

Question

Hi, 
 
 I change the configuration in proj.conf by adding 
 e.g. 
 CONFIG_SERIAL=n 
 
 It works . 
 
 However, I want to change similar things for the mcuboot_menuconfig after mcuboot is enabled, it seems it didn't work if writing something on proj.conf. 
 
 For mcuboot setting, it can only be set in the SES by Project>Congifgure NRF Connect SDK Project> mcuboot_menuconfig. 
 
 What is the way to change the configuration for mcuconfig simply like wiring on proj.conf? Is there any .conf file for mcuboot? 
 
 Thanks.

Håkon Alseth · Accepted Answer

Hi, 
 
 In your applications CMakeLists.txt file, you can add this just below the cmake_minimum_required() line: 
 if (EXISTS "${CMAKE_CURRENT_SOURCE_DIR}/spm.conf")
 set(spm_CONF_FILE
 prj.conf
 ${CMAKE_CURRENT_LIST_DIR}/spm.conf
 )
endif()

if (EXISTS "${CMAKE_CURRENT_SOURCE_DIR}/mcuboot.conf")
 set(mcuboot_CONF_FILE
 prj.conf
 ${CMAKE_CURRENT_LIST_DIR}/mcuboot.conf
 )
endif()

if (EXISTS "${CMAKE_CURRENT_SOURCE_DIR}/${BOARD}.overlay")
 set(mcuboot_DTC_OVERLAY_FILE "${CMAKE_CURRENT_SOURCE_DIR}/${BOARD}.overlay")
 set(spm_DTC_OVERLAY_FILE "${CMAKE_CURRENT_SOURCE_DIR}/${BOARD}.overlay")
endif() 
 
 This will allow you to create a mcuboot.conf file, with your wanted settings (in this case: CONFIG_SERIAL=n), as well as for the spm by adding wanted settings in spm.conf. 
 
 Note that this also overlays your settings to the spm and mcuboot settings (if applicable). 
 
 Cheers, 
 Håkon

Change mcuboot_menuconfig configuration

Top Replies