See logs in debug console while UART is comunicating with GPS

RE: See logs in debug console while UART is comunicating with GPS

Jared — Mon, 28 Sep 2020 13:57:22 GMT

Hi,

You wrote:

i am working with jlink segger edu, in a custom board, it dont have swd TX, RX pins connected

I interpreted this as you have not connected the SWD pins. I would prefer it if you could provide me with the schematics. It would clear up any misunderstandings.

regards

Jared

RE: See logs in debug console while UART is comunicating with GPS

Prayam — Mon, 28 Sep 2020 13:44:37 GMT

what do you mean in "these has to be connected "? i have conected SWDIO & SWDClK pins in SWD conector to SWDIO & SWDCLK pins in the MCU module respectively, wich swd pins must be conected with?

RE: See logs in debug console while UART is comunicating with GPS

Jared — Fri, 25 Sep 2020 12:08:47 GMT

Hi,

When the logger module use RTT as backend it uses the SWD pins. Which means that these has to be connected to use this feature. Could you provide a schematic of your custom board?

regards

Jared