installing SEGGER Embedded Studio for ncs sdk

RE: installing SEGGER Embedded Studio for ncs sdk

mregan11 — Tue, 06 Oct 2020 15:40:12 GMT

I was able to figure it out. Under Tools/Options/nRF Connect:

I changed Additional Make Options to 'None'. After doing that, I was able to open the Blinky project.

Thanks.

RE: installing SEGGER Embedded Studio for ncs sdk

mregan11 — Tue, 06 Oct 2020 13:33:14 GMT

I think I'm close. Below is my latest build error. Any ideas?

RE: installing SEGGER Embedded Studio for ncs sdk

mregan11 — Tue, 06 Oct 2020 13:32:34 GMT

I think I am close. Below is my latest error. Any ideas?

RE: installing SEGGER Embedded Studio for ncs sdk

Marte Myrvold — Tue, 06 Oct 2020 06:00:17 GMT

Hi,

How did you install SES? If you used the Toolchain Manager you should open SES through "Open IDE" there, in order to set the environment variables etc. correctly.

GNU ARM Embedded Toolchain Directory should be /ncs/v1.3.1/toolchain/opt, but I'm not sure if that's your problem. The problem might be that CMake is not added to your path, or not added correctly, as it says cmake not found. Your CMake path is probably something like C:\Program Files\CMake\bin, which should be added to the path in the systems environment variables.

Best regards,

Marte

RE: installing SEGGER Embedded Studio for ncs sdk

mregan11 — Mon, 05 Oct 2020 20:07:12 GMT

I'm still getting errors. I tried a different project and received a similar result. Note that I can build a project successfully from the Mac terminal. However I cannot open a project from SES.

Note that I am using a Mac.

RE: installing SEGGER Embedded Studio for ncs sdk

Marte Myrvold — Mon, 05 Oct 2020 09:15:35 GMT

Hi,

How are you opening the project? From the error it seems like you might be trying to open the file hello_worl.emProject. However, you should open the CMakeLists.txt file in the project folder, as shown in the picture below, just switch out the project with your project.

I would recommend that you check out this guide on building with SES. If you're still getting errors after following the guide, please let me know.

Best regards,

Marte