softdevice_hex option in Run-Time Environment

RE: softdevice_hex option in Run-Time Environment

Susheel Nuguru — Fri, 17 Jul 2015 08:48:02 GMT

Paul, Please update this thread accept/close with more information. Thank you

RE: softdevice_hex option in Run-Time Environment

Susheel Nuguru — Thu, 30 Apr 2015 10:38:12 GMT

updated the target.txt file to remove all unnecessary files. Remember to change the path of the softdevice hexfile in target_options->output tab->"select folder for objects"

RE: softdevice_hex option in Run-Time Environment

Susheel Nuguru — Wed, 29 Apr 2015 19:26:05 GMT

it did? That is so not so the design of it. I will verify this tomorrow and correct of anything that i screwed up.

RE: softdevice_hex option in Run-Time Environment

Paul — Wed, 29 Apr 2015 18:04:19 GMT

Hey Aryan. I just noticed that after copy the target.txt into the .proj file. It affected other targets. Added file groups to other targets. Please put a warning in your post before it messes up their project files if they forgot to back up. Thanks Paul

RE: softdevice_hex option in Run-Time Environment

Paul — Wed, 29 Apr 2015 16:56:18 GMT

Looks cool. I tried it. it gave me a new target in the IDE. If I want to change to S310 I just need to modify the related paths in the target.txt file? And why there are many .s and .c files listed in target.txt file?

RE: softdevice_hex option in Run-Time Environment

Susheel Nuguru — Wed, 29 Apr 2015 06:21:39 GMT

updated my answer to show how I normally add targets, I am not sure if there is some automatic way, but this works :)

RE: softdevice_hex option in Run-Time Environment

Paul — Tue, 28 Apr 2015 13:30:18 GMT

Thanks Aryan. No I didn't know they HAVE TO be separated. I will keep doing what I am doing then :-D But if you have a chance, please post some info for how to put a HEX image (SoftDevice Hex file) into Keil project. (the pack installer doesn't install the HEX file)

RE: softdevice_hex option in Run-Time Environment

Susheel Nuguru — Tue, 28 Apr 2015 09:38:07 GMT

Hi Paul,

Unfortunately you cannot mix the flashing of your softdevice with your project. You need to have atleast two targets, one for your application and the other to flash softdevice hex file.

Also the flashing through keil must be done seperately for each target. I think you cannot do it in one go unless you merge these two hex files or use nrfjprog tool.

If you already know this, then you might just be asking where to find the missing hex file. All the hex files are located in Keil_v5\ARM\Pack\NordicSemiconductor\nRF_SoftDevice_S110\8.0.0\hex (for example for S110) you see the hex files there. you can find all packs here developer.nordicsemi.com/.../ if there is no hex file in that pack, then probably it is not supported as a pack installer yet.

Update

Attaching the example target contents for S110 that you need to add into uvproj file to see one more target. target.txt

Open .uvproj file and add the contents of this text file as shown in the the image below

you will then see another target and you can later configure its settings however you like in Keil after opening the project.