NOT GETTING DEVICE NAME

RE: NOT GETTING DEVICE NAME

Carl Richard — Mon, 02 Nov 2020 10:01:04 GMT

I see. What happens if you run the same code on the DK?

Best regards,
Carl Richard

RE: NOT GETTING DEVICE NAME

sanjay kumar — Mon, 02 Nov 2020 09:03:19 GMT

No, I am not able to debug, after "kernel_init" it goes to switch_to_main_thread(); and then runs infinitely

RE: NOT GETTING DEVICE NAME

Carl Richard — Mon, 02 Nov 2020 08:54:34 GMT

Ah, my apologies. I misunderstood.

Are you able to debug the code and determine where in "device_get_binding" it gets stuck? I will try to do some testing here aswell.

Best regards,
Carl Richard

RE: NOT GETTING DEVICE NAME

sanjay kumar — Mon, 02 Nov 2020 04:50:37 GMT

I am using a custom board where sda and scl pins are connected to sensor, I am using nrf9160dk to program my custom board. So I cant connect to SDA to pin 10 and SCL to pin 11

RE: NOT GETTING DEVICE NAME

Carl Richard — Fri, 30 Oct 2020 15:24:32 GMT

Hello!

I'm looking at your issue. The pins you are currently using are reserved for other purposes on the nRF9160DK. Could you try for instance to map SDA to pin 10, SCL to pin 11 and the gpio0 to pin12?

Best regards,
Carl Richard