Bluetooth Peripheral UART no console output

RE: Bluetooth Peripheral UART no console output

zuppiden — Fri, 06 Nov 2020 12:40:50 GMT

I flashed the network core again and it works now. Thanks.

RE: Bluetooth Peripheral UART no console output

Edvin — Mon, 02 Nov 2020 13:43:44 GMT

I assume you also flashed the network core, since you got the peripheral_lbs up and running. If you have not flashed it, please check out the NCS getting started Guide part 1, and see the section 2.2.1 Build a BLE example.

RE: Bluetooth Peripheral UART no console output

Edvin — Mon, 02 Nov 2020 13:42:25 GMT

Hello,

When I build and flash the peripheral_uart example from SDK1.3.2, and I get the following terminal output:

*** Booting Zephyr OS build v2.3.0-rc1-ncs3  ***
Starting Nordic UART service example
I: 2 Sectors of 4096 bytes
I: alloc wra: 0, fd8
I: data wra: 0, 1c
I: No ID address. App must call settings_load()
Bluetooth initialized

Are you not seeing the same?

If not, make sure you are using the same COM port (the same as the one that you see the output from the lbs example). Also, try to close and re-open the terminal, and see if it appears.

Best regards,

Edvin