About the interrupt of L01+

RE: About the interrupt of L01+

Carlos Cuevas — Tue, 22 Oct 2013 01:18:05 GMT

No, it doesn't have to be connected. So you write 0xFE to the CONFIG if the PTX and 0xFF to the CONFIG of PRX as well, right?

If that's the only thing you're doing you're also missing writing to the RX_PW_P0 register on the PRX the size of the payload it will be expecting, as the default is 0.

Also don't forget to set the CE pin to 1 to be in active mode in both PRX and PTX.

RE: About the interrupt of L01+

John — Tue, 22 Oct 2013 01:05:39 GMT

I do the setting for the L01+: 1、No Auto acknowledgement and Auto Retransmission； 2、Interrupt does not reflects on the IRQ pin(by writting 0xFE to CONFIG register) and leave the IRQ pin unconnected(the IRQ pin does not connect to MCU).

As a result,I found that RF communication is failed .Must the IRQ pin connect to MCU and interrupt reflect on the IRQ pin?

RE: About the interrupt of L01+

John — Tue, 22 Oct 2013 01:00:59 GMT

As a result,I found that RF communication is failed .Must the IRQ pin connect to MCU and interrupt reflect on the IRQ pin?

RE: About the interrupt of L01+

Carlos Cuevas — Sun, 20 Oct 2013 11:28:12 GMT

Are you sure you're not disabling the interrupts on IRQ pin? This is done in the CONFIG (0x00) register.