How can I flash the E104-BT5032A-TB using Windows 8.1?

RE: How can I flash the E104-BT5032A-TB using Windows 8.1?

amr87 — Fri, 30 Apr 2021 03:08:50 GMT

Hi,

I have tried also flashing the E104 module as same as you,

So far, After looking around on the forum, I able to flash the module with Arduino IDE via StlinkV2.

I just erase all memory inside the module with RaspberryPi and openocd by following this steps:

https://iosoft.blog/2019/01/28/raspberry-pi-openocd/

and for the command that I have used, I follow this tutorial:

https://mcuer.sikamo.net/blog/flashing-nrf5-without-jlink/

RE: How can I flash the E104-BT5032A-TB using Windows 8.1?

artyeduino — Sun, 20 Dec 2020 19:49:04 GMT

thanks abdelali

Yes, that is true - But I have so many tools that I bought over the years and I want to put them into good use - i read and saw that it can be done using the STLink V2 to program the nRF52 board.

I saw that getting started you have sent - they use the nRF52 DK of which I don't have right now and I can't follow the instructions there.

I would be happy if someone can help me with the wiring of the board to the STLinkV2. What should I connect over the already connected wires as i have mentioned. 3v3 and GND - and SWDIO and SWDCLK.

I would be happy to be able to start programming the nRF devices using the Hardware That i already have and to learn how to do that using the CORRECT software as well. I know that this is the RIGHT place to get the information I am looking for and get the knowledge out of you guys that works and understand the nRF inside-out.

I need to understand the basics using the HW I have at hand - I would be happy to get to the next step of developing the nRF52 by myself.

Thanks,

Aryeduino

RE: How can I flash the E104-BT5032A-TB using Windows 8.1?

abdelali — Sun, 20 Dec 2020 17:41:19 GMT

Hi,

Your life would be much easier if you just bought an nRF52 DK instead !

Have a look this getting started tutorial. It should help you getting started with that.