nrf52833 beacon messages

RE: nrf52833 beacon messages

Muhammad Usman — Fri, 12 Feb 2021 20:15:30 GMT

HI Simon ,

Thank you ! for your wounderful support .Sorry in previous post it was my mistake . I forget to change the linker section according to the pca10100. I attached the image with highlighted area . Now its working . I have not tested the full program but its started successfully with startup message on serial Terminal .

Docklight Output

RE: nrf52833 beacon messages

Muhammad Usman — Fri, 12 Feb 2021 20:04:29 GMT

thank you for your support !

i just port the pca10056 project to pca10100 as per the instructions above . I also attached the snap shot . But unable to get the required output .Start of the program was printing the hello message in pca10056 SDK but when converted ti pca10100 get no output to serial port . Although , i tested other programs examples for pca10100 they are displaying the startup message on serial terminal .

Your suggestions are very precious for me .Thanks in advance

RE: nrf52833 beacon messages

Simonr — Fri, 12 Feb 2021 11:54:00 GMT

If we can close this case, please let me know by verifying one or more answers in this thread you found helpful, to let users in the future with the same question can easily find what they are looking for.

Best regards,

Simon

RE: nrf52833 beacon messages

Muhammad Usman — Fri, 12 Feb 2021 10:18:34 GMT

Hi Simon

Thank you so much for the support !

Best Regards,

Usman

RE: nrf52833 beacon messages

Simonr — Fri, 12 Feb 2021 07:27:34 GMT

Please check out this case where my colleague Hung suggests the easiest way to port any pca10056 project (nRF52840 DK) to pca10100 (nRF52833 DK).

Best regards,

Simon

RE: nrf52833 beacon messages

Muhammad Usman — Thu, 11 Feb 2021 16:56:42 GMT

Hi Simonr!

Thank you ! for your expert opinion regarding my problem . I will definitely test and update on the forum about the results.

One thing more i have seen in this link .

https://devzone.nordicsemi.com/f/nordic-q-a/69595/problem-with-scanning-1mbps-and-coded-phy-at-the-same-time/286015#286015

Can you please have a look into it , that can we modify it from NRF52840 to work for NRF52833?

Again Thanks & Regards

RE: nrf52833 beacon messages

Simonr — Thu, 11 Feb 2021 13:48:52 GMT

We don't have any example projects doing this by default, but you can check out these modified ble_app_uart examples for peripheral and central, that does advertising and scanning over the Coded PHY. You can use these examples as templates to see how the advertising and scanning should be configured though.

Additionally, please also make sure that the init.advdata.flags is set to BLE_GAP_ADV_FLAGS_LE_ONLY_GENERAL_DISC_MODE as I think that's missing from the peripheral if memory serves correctly.

You can also check out this case, where myself and a customer discuss the necessary central and peripheral settings for using Coded PHY as well.

Best regards,

Simon

devzone.nordicsemi.com/.../6724.Long_5F00_range_5F00_15.2.zip