DTM Receiver test on Connectivity board, PACKET COUNT is few.

RE: DTM Receiver test on Connectivity board, PACKET COUNT is few.

run_ar — Thu, 18 Mar 2021 14:05:16 GMT

Hi,

As far as I can see the serialization example disables the SD, then shuts down serialization before starting DTM. In dtm it looks like it should work just like standalone dtm, except it will recieve dtm commands from the application mcu. Let me see if I can recreate your issue.

RE: DTM Receiver test on Connectivity board, PACKET COUNT is few.

H.O — Fri, 12 Mar 2021 00:58:12 GMT

Hi run_or-san,

Thank you for your reply.

My system structure is Host MCU and nRF52832. Interface is UART.

Normally, Host MCU controls nRF52832 for BLE communication.

If BLE Test Mode is started, the operation for this question will be done.

The DTM function for serialized application is included in nRF5 SDK sample code.

I uses software "\nRF5_SDK_17.0.2_d674dde\examples\connectivity\ble_connectivity".

For the DTM, it has not interrupt handler. it is executed in single task.

Did you confirm this source code? Can you execute it correctly on your board?

Best regards,

H.O

RE: DTM Receiver test on Connectivity board, PACKET COUNT is few.

run_ar — Thu, 11 Mar 2021 08:59:19 GMT

Hi,

Can you elaborate a little around what it is you are doing? If I understand correctly you have added uart DTM to a serialized application? Notice that DTM is made as a standalone application and does not work well if there are other higher priority tasks running at the same time.