RE: Device Tree modification in SES

Heidi — Wed, 07 Apr 2021 07:52:12 GMT

Hi!

When changing the configurations of your project (Kconfig, device tree, CMake, board, etc.), you need to use "Project -> Run CMake" or load the whole project again for these changes to be included in the build.

The reason for this is that SES only does the configuration phase when you load the project. So if you make changes to the files used in the configuration phase, those changes aren't included until you run the phase again, either by loading the project again or using "Run CMake".

Best regards,

Heidi