Is it possible to over write nrf52840 dongle that already been flashed earlier with new .hex file

RE: Is it possible to over write nrf52840 dongle that already been flashed earlier with new .hex file

Elfving — Tue, 11 May 2021 11:19:15 GMT

I see. The nRF52840 Dongle can be a bit difficult. If you aren't too familiar with it I would suggest getting yourself a DK, or at least trying one of the Blinky examples for the dongle to get used to it.

Btw, did you put the Dongle in DFU mode before trying the nRF Connect Programmer?

Install nRF Command Line tools from here, and try nrfjprog again. It can help you with the sectorial erase you are referring to. To find what parts to erase you can read the chip using the nRF Connect Programmer.

Best regards,

Håkon

RE: Is it possible to over write nrf52840 dongle that already been flashed earlier with new .hex file

UmaMaheswar — Mon, 10 May 2021 12:27:15 GMT

Sorry I don't know what actually NCS is and I want to flash the new firmware [.hex] file that I got from here and the image that I used earlier is NCP [mbr10059.hex] from nrf thread and zigbee SDK. I don't have any Debugger or DK with me.

RE: Is it possible to over write nrf52840 dongle that already been flashed earlier with new .hex file

Elfving — Mon, 10 May 2021 12:05:53 GMT

Any command line will do. Assuming you are using Windows, just open the windows start menu and find "cmd", or press Windows Key+r, and then type cmd.

Are you using NCS or SDK btw?

Best regards,

Håkon

RE: Is it possible to over write nrf52840 dongle that already been flashed earlier with new .hex file

UmaMaheswar — Mon, 10 May 2021 08:45:52 GMT

Sorry, I'm new here and couldn't find Command line here in nrf connect Programmer.

And I of course know how to program a dongle i.e just by adding a .hex file but my issue here is I have a dongle that already has a hex file and need to overwrite that firmware with new firmware using new .hex file, I found that to do sectorial erase we need a debugger that I cannot get now and want to program this dongle without erasing it's bootloader and some required things.

RE: Is it possible to over write nrf52840 dongle that already been flashed earlier with new .hex file

Elfving — Mon, 10 May 2021 08:09:38 GMT

Hi UmaMaheswar!

There are several ways to flash a new hex file to the nrf52840 Dongle, but using the nRF Connect Programmer should work as well. Have you chosen the correct device from the top left drop down menu? And would you mind running "nrfjprog -i" in command line and telling me the output?

Best regards,

Håkon