Throughput ATT MTU Test stuck after "Notifications enabled"

RE: Throughput ATT MTU Test stuck after "Notifications enabled"

Simonr — Mon, 07 Jun 2021 08:11:04 GMT

Not exactly. It should be possible to see the log from the responder as well as the tester. I just tested the throughput example in a fresh version of the SDK v17.0.2, and I was able to run it successfully. Here is a screenshot of both tester and responder. Can you also provide a log of your responder so we can see if it stops at the same point as well? If so, I think you should open an RTT viewer to see the debug log on your devices. The test should run by itself as long as you have an active responder and type run in the tester terminal.

Best regards,

Simon

RE: Throughput ATT MTU Test stuck after "Notifications enabled"

nothingmuchyou — Fri, 04 Jun 2021 14:20:11 GMT

Do you mean switch the roles of tester and responder and see if I get the same result?

RE: Throughput ATT MTU Test stuck after "Notifications enabled"

Simonr — Fri, 04 Jun 2021 07:30:28 GMT

Can you also provide the logging of the other DK? Does it "stop" in a similar place? I will run a test on my day on Monday, when I am in office and have the required amount of DKs available.

Best regards,

Simon

RE: Throughput ATT MTU Test stuck after "Notifications enabled"

nothingmuchyou — Thu, 03 Jun 2021 13:19:48 GMT

Yes I followed the entire setup, and no I didn't change anything in the example project. I don't think it's waiting, because LED2 is lit up. LED1 seems to be the waiting LED. I pressed button 3 and button 4 on each board to put them in tester and responder mode.

RE: Throughput ATT MTU Test stuck after "Notifications enabled"

Simonr — Fri, 28 May 2021 12:06:04 GMT

Have you followed the steps for setup and testing in the example documentation? After this message I think the device is waiting for the other DK, so I don't think it is stuck, but rather waiting. Please make sure that you've put one DK in responder mode and one in the tester mode.

Have you made any changes to the example project at all?

Best regards,

Simon