Debugging Mode Only When Supplied With External Supply

RE: Debugging Mode Only When Supplied With External Supply

Burnie Barren — Fri, 10 Sep 2021 11:02:06 GMT

My problem is resolved in this ticket.

RE: Debugging Mode Only When Supplied With External Supply

Burnie Barren — Fri, 10 Sep 2021 09:38:55 GMT

Hello Jared,

Yes, and on returning to nominal values after pressing reset button. What am I missing?

RE: Debugging Mode Only When Supplied With External Supply

Jared — Fri, 10 Sep 2021 09:35:50 GMT

Hi there,

How do you determine that the chip inters debug mode when you use external supply versus the other configurations? Is it based only on the current draw?

regards

Jared

RE: Debugging Mode Only When Supplied With External Supply

Burnie Barren — Thu, 09 Sep 2021 12:28:17 GMT

In addition to this, from time to time current supplied by the external sources reaches 100 mA limit and LD5 blinks per sec. I am saying 'from time to time' because literally I just turn off the source then turn it back on. It either hits 100 mA, debugging mode or runs smoothly. In all of these cases, beacon package is successfully sent. I kept soldering and desoldering the bridges SB11, 12 and 29. I feel like I have caused a loose contact or short somewhere but I have checked all that comes to my mind, negative. I would be glad if someone could shed some light on this.