Implementing direct streaming from NRF51822 to PC without GATT

RE: Implementing direct streaming from NRF51822 to PC without GATT

Hung Bui — Mon, 06 Jul 2015 13:46:39 GMT

@Mobi:

Using lower layer (L2CAP) can help you with a little bit more data rate because of bigger payload size (+3 bytes in the payload) but won't help much.
Yes you can use IPv6 on the same board. But the data rate won't change. Also you need to make sure your internet infrastructure fully support IPv6.
We can continue on this case if you want to use gazell. Note that unless you use 2Mbps data rate, Gazell won't be much faster than BLE.

mobi — Sun, 05 Jul 2015 14:18:57 GMT

I was aware of that and we are using it for some debugging. But we need stream on Radio using Bluetooth or using some other stack to PC side.

Bill Siever — Sun, 05 Jul 2015 14:08:16 GMT

If you can do your debugging/streaming while connected with wires, you might want to just use Segger's RTT (search for other posts on this forum or see Vebjørn's blog post https://devzone.nordicsemi.com/tutorials/6/debugging-with-real-time-terminal/)