NRF52840PDK core getting stuck after debugging using NRF Connect SDK1.7 and SES

RE: NRF52840PDK core getting stuck after debugging using NRF Connect SDK1.7 and SES

Marte Myrvold — Tue, 16 Nov 2021 14:47:00 GMT

Hi,

This is most likely because the PDK is not supported in nRF Connect SDK. The PDK has an engineering SoC that is missing features and erratas that are in the later versions of the SoC. PDKs should only be used for evaluation purposes, and I would recommend getting a DK instead.

Best regards,

Marte

RE: NRF52840PDK core getting stuck after debugging using NRF Connect SDK1.7 and SES

annamol — Tue, 16 Nov 2021 06:53:17 GMT

When we try to program the PDK using west, command prompt doesn't show any error messages, but code won't run.

The same set of commands works fine with NRF52840DK.

Do we need to change the board name while using west command for flashing?

RE: NRF52840PDK core getting stuck after debugging using NRF Connect SDK1.7 and SES

Marte Myrvold — Wed, 10 Nov 2021 14:01:27 GMT

Hi,

Are you able to successfully program the PDK using west on command line, or do you see the same issue there as with build and run?

Please be aware that the nRF52840 PDK is not officially supported in nRF Connect for SDK. See Compatibility Matrix > SDKs and SoftDevices and Compatibility Matrix > Development hardware for more information

Best regards,

Marte