Nrf52805 with Segger Studio

RE: Nrf52805 with Segger Studio

Marte Myrvold — Fri, 21 Aug 2026 07:20:09 GMT

Hi,

I cannot find anything in our datasheet or the datasheet for MS46SF11 indicating that there should be any problems using P0.05.

This ticket is more than 5 years old. Please create a new ticket with more information about the issue. Thank you.

Best regards,
Marte

RE: Nrf52805 with Segger Studio

Daniel01 — Mon, 17 Aug 2026 18:12:08 GMT

Hi, I have a question. I've been using pin P0.04, and it works fine, but pin P0.05 doesn't do anything. I have two modules, and they both do the same thing. Is this normal?

RE: Nrf52805 with Segger Studio

Marte Myrvold — Mon, 22 Nov 2021 07:18:39 GMT

Hi,

The nRF52805 is supported out of the box in nRF Connect SDK (see nRF52805 > Compatibility Matrix > SDKs and SoftDevices), but you can also use the nRF5 SDK by porting a nRF52832 example as explained in Developing for the nRF52805 with nRF5 SDK.

We do not have any guides for MS46SF11, but there is a similar case here: Problem with getting started with software development on nRF52805 where this module is used. However, this is for the nRF5 SDK. For developing for nRF52805, you can use a nRF52 DK with a nRF52832 SoC to simulate the nRF52805. In nRF Connect SDK this is done by using nrf52dk_nrf52805 as build target (see nRF52805 emulation on nRF52 DK). You can use SEGGER Embedded Studio with both nRF Connect SDK and nRF5 SDK, see nRF Connect SDK » Getting started and Getting started with nRF5 SDK and SES (nRF51 & nRF52 Series).

Best regards,

Marte