Run Cmake fails often in Segger Embedded Studio for same Project

RE: Run Cmake fails often in Segger Embedded Studio for same Project

ErwinCes — Wed, 15 Dec 2021 13:24:26 GMT

I changed to a different browser (now edge) as with firefox a logout was not possible. It ended in an endless weblink loop. Now with the new browswer.

I have to say, that I haven't seen this error since two days anymore. So maybe we close this issue. For my other problems I will create different tickets.

RE: Run Cmake fails often in Segger Embedded Studio for same Project

Didrik Rokhaug — Mon, 13 Dec 2021 16:46:37 GMT

[quote user="ErwinCes"]My observation was: I create the project new, it then compiles and then I press CMake in the run Menu. And this CMake then fails.[/quote]

That is strange. I tried to reproduce it, but wasn't able.

Do you get the error when using unmodified (other than moving them) samples?

Where do you move them from, and where do you move them to?

Do you open SES from the Toolchain Manager?

Do you see the same error if you build with West on the command line?

RE: Run Cmake fails often in Segger Embedded Studio for same Project

ErwinCes — Mon, 13 Dec 2021 09:52:15 GMT

That makes sense, but doesn't work when I re-run CMake without having anything changed. My observation was: I create the project new, it then compiles and then I press CMake in the run Menu. And this CMake then fails.

Strange.

RE: Run Cmake fails often in Segger Embedded Studio for same Project

Didrik Rokhaug — Mon, 13 Dec 2021 09:33:33 GMT

Hi,

When you re-run CMake, it will still use some cached information from earlier builds, including file paths.

Therefore, when you move the project to a new location, you need to do a pristine build. You can do that by selecting the "Clean build directory" checkbox, or by deleting the build folder manually (or selecting a new one).

Best regards,

Didrik