RE: Handing nmea 0183 gps receiver data over UART

Edvin — Mon, 10 Jan 2022 14:18:27 GMT

Hello,

If you see the "fatal error" message, you should define "DEBUG" in your preprocessor definitions. If you are not certain how to do this, please let me know what IDE you are using (Segger Embedded Studio/Keil/IAR/armgcc).

Then check what the log says after you have defined DEBUG in your preprocessor definitions. Does it point to somewhere in your project? What function returned the error, and can you find out why?

When you had the "unreliable" data? How did you set up the UART?

Best regards,

Edvin