nRF9160 DK & Custom board

RE: nRF9160 DK & Custom board

Alskandar — Thu, 03 Feb 2022 21:54:29 GMT

I don't know why but after restarting the method for the 100th time, it works.

1 to 3uA for the nRF9160DK and around 30-40uA for the custom board, as expected.

I keep moving forward, thanks for the help!

RE: nRF9160 DK & Custom board

Kenneth — Thu, 03 Feb 2022 15:42:52 GMT

Do you power cycle the board after programming to exit debug mode? Did you test the pre-compiled hex file in the link I shared?

Kenneth

RE: nRF9160 DK & Custom board

Alskandar — Thu, 03 Feb 2022 14:40:52 GMT

Hi, thanks for answer.

I use an Otii Arc as Power analyser with SMU mode (SMU- (GND), USB and SMU+).
I think i'm good on this point.

I don't have a child image on my program.
I build and upload through VS Code.

I tested an other simple program putting CONFIG_SERIAL=n on the SPM part. Always 600uA.
That should give 30-40uA apparently.
devzone.nordicsemi.com/.../icarus_2D00_current_2D00_consumption_2D00_test.zip

RE: nRF9160 DK & Custom board

Kenneth — Thu, 03 Feb 2022 12:52:40 GMT

You may find this useful just to verify that you measure correctly:
https://devzone.nordicsemi.com/guides/cellular-iot-guides/b/hardware-design/posts/getting-started-with-current-measurements-on-the-nrf9160

You have set CONFIG_SERIAL=n in your application, but it may be that you have several child images that are also compiled, and these may also need to set CONFIG_SERIAL=n. For more information about child images see:
https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/ug_multi_image.html