Coded phy for throughput example with nrf connect sdk 1.8

RE: Coded phy for throughput example with nrf connect sdk 1.8

dejans — Wed, 09 Feb 2022 12:33:33 GMT

Hi Nick,

There is an option you need to add to the configuration file (prj.conf) - CONFIG_BT_CTLR_PHY_CODED=y.
Afterwards, both coded_s2 and coded_s8 should work normally.

Best regards,
Dejan

RE: Coded phy for throughput example with nrf connect sdk 1.8

dejans — Mon, 07 Feb 2022 14:05:42 GMT

Hi Nick,

I asked internally about the throughput sample. I'll get back to you when I get more information.

Best regards,
Dejan

RE: Coded phy for throughput example with nrf connect sdk 1.8

Nikkolaus — Mon, 07 Feb 2022 10:17:03 GMT

Hello again,

Thank you for the answer :)

It doesn´t matter if I configured only one or two of my boards with coded phy. (It should not be depended in general what the peripheral device is configured. The central sends a phy update anyway, or I´am wrong?)

I use two nRF52840-DK´s and each of them are connect via COM with my computer and I use PUTTY to configure the central one.

The example works fine for the other two phy´s, so I´am think the Hardware is configured right.

RE: Coded phy for throughput example with nrf connect sdk 1.8

dejans — Fri, 04 Feb 2022 16:35:22 GMT

Hi Nick,

I have managed to reproduce what you reported but without the error code.
Are you experiencing problem only when one of the devices is configured for coded PHY or only when both are using coded PHY?
Please provide more information about devices' physical configurations which do not work for you.

Best regards,
Dejan