Using Mesh sample over Coded PHY

RE: Using Mesh sample over Coded PHY

Matt Ruffner — Fri, 28 Feb 2025 21:21:05 GMT

Hi Rajeev,

Have you tested this out? I am also working on implementing coded PHY over mesh. Specifically I am trying to figure out how to enable the 125kbit S=8 PHY.

RE: Using Mesh sample over Coded PHY

Rajeev K R — Mon, 22 Apr 2024 05:45:54 GMT

Hi Sushel

I wish to implement the same, have you made the Mesh Implementation in Zephyr, if yes were you able to implement it? since mesh has multiple advertisment packets, will changing the PHY of one adv packet convert the entire mesh to coded phy.. if yes then this is great news. if you have any resourse that you can share please do, this will help us a lot

Thanks

RE: Using Mesh sample over Coded PHY

Susheel — Fri, 11 Feb 2022 10:30:18 GMT

Hello,

After including the above mentioned project configurations and parameters, you would have to make one additional change.

In the bt_mesh_scan_cb() function in adv.c file, there is an initial check to filter in a specific type of advertisement(BT_GAP_ADV_TYPE_ADV_NONCONN_IND). This is according to the bluetooth Mesh spec. To allow extended messages, you would have to replace this with BT_GAP_ADV_TYPE_EXT_ADV.

Voila! you have mesh over long range using nRF connect SDK

RE: Using Mesh sample over Coded PHY

Susheel — Thu, 10 Feb 2022 16:15:32 GMT

Hello Mttrinh,

I am working with v 1.8.0 toolchain and am using the sample from "..\ncs\v1.8.0\zephyr\samples\bluetooth\mesh"

RE: Using Mesh sample over Coded PHY

Mttrinh — Thu, 10 Feb 2022 15:32:54 GMT

Hi,

Which version of nRF Connect SDK are you using? And which mesh sample are you using?