nRF51 Dongle not does not find devices anymore after firmware update in third party app.

[fungiking]

Hello everybody

I am using the nRF51 Dongle to connect via a third party app to a measuring device. This always worked very well on my first computer, the app could detect the dongle, scan for bluetooth devices and then connect to the measuring device. However, while setting up the third party app on a different computer, I accidentally updated the firmware of the device to version "2022 Jan 20 16:43" as seen in the picture below in the J-Link Configuration (unfortunately I do not know the old version). All the threads which have a similar problem, are solved with dead links to older firmware. Is there a possibility to roll back to some later version of the firmware? If yes, how can I do so?

Many thanks for your help and support.

Sincerely,
Chris

[Edvin]

Hello,

I am not necessarily convinced that it is the Segger JLink FW that causes the issue. Is the FW on the nRF the same as it was when it was working, or have you erased it?

What does your nRF51 dongle look like? Does it have a PCA number (on a sticker somewhere on the dongle)?

BR,
Edvin

[fungiking]

Hi, thanks for your fast response. It is not the same FW anymore and as it is the only thing I change between when it was working and when it stopped working I assumed that must be the problem. The PCA is 10031 and that's how it looks like:

[Edvin]

So the application on the nRF is no longer the same, is that what you are saying?

If so, 

This always worked very well on my first computer, the app could detect the dongle, scan for bluetooth devices and then connect to the measuring device.

Then it may not be that strange that it is no longer working?

What firmware was flashed on the nRF51 dongle? (the nRF51 chip, not the Segger chip)

BR,
Edvin

[fungiking]

Ah sorry then I did not understand you correctly. We do not have any application on the nRF we only use it as a Bluetooth "antenna". The third party windows app was able to detect Bluetooth devices when the dongle was plugged in to the computer. Please see the picture below. I could click on "Scan" and then after a few seconds in the upper left white rectangle a lot of devices could be seen, however after the firmware update it stays blank and it only says "scanning for devices". The app is however still able to detect the nRF as the Scan button only gets released when the program is "connected" to the dongle.